User's Manual
Table Of Contents
- About This Manual
- Getting Started
- Using the Hardware
- Making RFID Applications
- Using Smart-Reader Server
- Controlling Smart-Reader Server Remotely
- Installing Microsoft .NET Framework
- Installing the SRSRC Program
- Using the Smart-Reader Server Remote Control
- Configuring Antenna Port
- Defining Smart Reader Behavior
- Creating a New EC Spec
- Specifying Report Criteria
- Setting up Filter Rules
- Defining the EC Spec
- Subscribing the EC Spec
- Redefining the Subscription
- Viewing Data Collection Report
- Viewing Server Log
- Using the Application Programming Interface
- Connecting to BizTalk Server
- Connecting to Oracle Sensor Edge Server
- Advanced Settings
- Troubleshooting
- System Specification
- Support
Chapter 2 Using the Hardware
8
Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Using the GPIO Interface
Use the GPIO Cable to connect the RS700 to several external controls such as an
LED indicator lamp, LCD or motion sensor.
GPIO Pin Assignment
Connect two relay output and digital input signals with the 10-pin GPIO cable. Con-
nect external devices through the following:
Pin Name Description
10. DI1-1. DIX: Digital Input (X=1; 2).
DIX-1: Input Voltage (3.3V - 12V).
DIX-2: Ground.
9. DI1-2.
8. DI2-1.
7. DI2-2.
6. RL1C. RLX: Relay (X=1; 2).
C: Common.
NC: Normal Close.
NO: Normal Open.
5. RL1NC.
4. RL1NO.
3. RL2C.
2. RL2NC.
1. RL2NO.
Pin1 . . . . . . . . . 10
DIX-1
DIX-2
RLXC
RLXNO
RLXNC