User's Manual
Table Of Contents
- About This Manual
- Getting Started
- Using the Hardware
- Making RFID Applications
- Using Smart-Reader Server
- Controlling Smart-Reader Server Remotely
- Installing Microsoft .NET Framework
- Installing the SRSRC Program
- Using the Smart-Reader Server Remote Control
- Configuring Antenna Port
- Defining Smart Reader Behavior
- Creating a New EC Spec
- Specifying Report Criteria
- Setting up Filter Rules
- Defining the EC Spec
- Subscribing the EC Spec
- Redefining the Subscription
- Viewing Data Collection Report
- Viewing Server Log
- Using the Application Programming Interface
- Connecting to BizTalk Server
- Connecting to Oracle Sensor Edge Server
- Advanced Settings
- Troubleshooting
- System Specification
- Support
Chapter 2 Using the Hardware
7
Installing RFID Antenna (Optional)
The RS700 has four RFID Antenna Ports (ANT1, ANT2, ANT3, and ANT4) and two
removable protection caps on ANT2 and ANT3.
NOTE: Only remove the protective caps for installing RFID Antennas.
Install an RFID Antenna through the following:
1. Locate the RFID Antenna Ports on the RS700’s top panel.
2. If necessary, remove the protection caps on ANT2 and ANT3.
3. Connect the Antenna Cable to the desired RFID Antenna Port, and rotate the
cable cap clockwise to secure the connection.
4. Connect the other end of the Antenna Cable to the wall mounted RFID
Antenna, and rotate the cable cap clockwise to secure the connection.
NOTE: Refer to the RFID Antenna Installation guide for mounting the RFID
Antenna(s).
WARNING!To avoid radiation exposure, the RFID Antennas should be installed
and operated with minimum distance 1000mm away from the human
body.