User's Manual
Table Of Contents
- About This Manual
- Getting Started
- Using the Hardware
- Making RFID Applications
- Using Smart-Reader Server
- Controlling Smart-Reader Server Remotely
- Installing Microsoft .NET Framework
- Installing the SRSRC Program
- Using the Smart-Reader Server Remote Control
- Configuring Antenna Port
- Defining Smart Reader Behavior
- Creating a New EC Spec
- Specifying Report Criteria
- Setting up Filter Rules
- Defining the EC Spec
- Subscribing the EC Spec
- Redefining the Subscription
- Viewing Data Collection Report
- Viewing Server Log
- Using the Application Programming Interface
- Connecting to BizTalk Server
- Connecting to Oracle Sensor Edge Server
- Advanced Settings
- Troubleshooting
- System Specification
- Support
6
Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Chapter 2
Using the Hardware
The RS700 contains two Antenna Ports for wireless signal enhancement and RFID
reading points.
Installing Wi-Fi Antenna
There are two Wi-Fi Antenna Ports on the RS700 (Wi-Fi ANT1 and Wi-Fi ANT2).
Install a Wi-Fi Antenna through the following:
1. Locate the Wi-Fi Antenna Ports on the RS700’s top
panel.
2. Connect a Wi-Fi Antenna to a desired Wi-Fi Antenna
Port, and rotate the antenna cap clockwise to secure
the connection.
3. Bend the Wi-Fi Antenna(s) to a 90-degree angle.
DATA RFID PWR
PWR+RS232
RESET
GP I/0
BACKUP
SW