User's Manual
Table Of Contents
- PA982 Ultra Rugged Mobile Computer
- About This Manual
- Getting Started
- Introducing the PA982
- Features
- Package Contents
- A Tour of the PA982
- Setting up the PA982
- Installing the Battery
- Charging the Battery
- Charging the Battery using the RS232 Charging Cable
- Charging the Battery with the Docking Station
- Checking the Battery Status
- Connecting the PA982 to a PC
- Turning the PA982 on for the First Time
- Powering On
- Calibrating the PA982 Screen
- Setting the Time and Date
- Adjusting the Screen Brightness
- Using the Hardware
- Getting Connected
- Barcode Scanner Programs
- Advance settings
- System Specifications
8
Copyright 2006 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Charging the Battery
Before using the PA982 for the first time, you need to charge it for about 16 hours.
After that, you can charge the PA982 every day to recharge the battery to full capacity.
Charge the PA982 using the RS232 charging cable or the docking station.
CAUTION! Operating the PA982 for the first time without the AC adapter, and
without fully charging the backup battery may result in loss of data
stored in RAM memory.
When the main battery is removed, the backup battery retains RAM
data in memory for 2 hours; charge the battery as soon as possible to
avoid the data loss in RAM memory.
Charging the Battery using the RS232 Charging Cable
1. Connect the RS232 charging cable connector to the PA982 (1).
2. Plug the AC adapter cable into the power jack on the RS232 serial
connector (2).
3. Connect the AC adapter into an electrical outlet (3).