User's Manual

- 4 -

※If you need Operation Manual and Installation guide, please check with the

dealer.

MT200 SERIES Installation Notes

 Connect Power

Plug the Power Adapter Cable into the MT200 SERIES’s DC input jack, then connect

the other end of the Power Adapter into an electrical outlet.

 Using Terminal Block

The MT200 SERIES provides one 10-position terminal blocks for input/output signals.

The I/O panels are on the MT200 SERIES’s rear side.

 Installation (I) – Plastic in wall box

Mount and fix the MT200 SERIES terminal with four screws (M2 x 20mm) to the

housing embedded into the wall. Next, install an upper plaque and a lower plaque for

ornaments on the cover of MT200 SERIES terminal.

The upper and lower plaques are consumptive materials, so carefully attach the two

plaques. If the materials are damaged, please contact your dealer for solution.

MT200 is a door phone with front panel IP65 degree. While outdoors on-site installation,

please have "shield case" to protect the device to avoid the rain flows into device body

that might be resulting in oxidation or short circuit. While installing the device in the wall,

please use "Silicone" sealing the gap between the device with the wall to prevent

infiltration of rainwater from the wall surface.