User's Manual

Scenario III - Trigger Security Alarm

Disconnect Pin 5 (SAFE) to Pin 10 (GND) to

loosen the loop while the security ban is set. The

loosened loop triggers the security alarm, and

SecuredAlarm displays on the standby screen.

Press À to enter the security setting screen. Th

current security status, Secured displays

onscreen. Swipe the card on the Proximity Reader,

the security status switches to SecuredRelease

indicating that the security ban is lifted.

SecuredAlarm disappears on the standby screen.

Check the loop and reconnect Pin 5 (SAFE) to Pin

10 (GND).

Anti-Pass Back Setting

Enforce Anti-Pass Back to control the entrance/exit behavior and prevent unauthorized access. Utilize

MTTool to prohibit same card reentry and re-exit through the same door.

1. Connect a secondary reader to MT180 via RS232 Drive.

NOTE: While MT180 serves as an internal reader, the secondary reader is the external reader.

Ensure the card type is compatible with the internal/external reader.

2. Set MT180 and the computer on the same subnet network.

3. Execute MTTool on the computer.

! Alarm

SecuredAlarm

Unitech

XX:XX:XX

SecuredStatus...

SecuredRelease

PressCard

Secured

PressCard

Unitech

XX:XX:XX

2009.1.8 Thur.

RS232 Drive