User's Manual

Preface

About This Manual

This manual explains how to install, operate and maintain MT180 IP-based Access Control

Terminal.

No part of this publication may be reproduced or used in any form, or by any electrical or

mechanical means, without permission in writing from the manufacturer, which includes but is

not limited to photocopying, recording, or information storage and retrieval systems. The

material in this manual is subject to change without notice.

Unitech TASHI Website: http:\\www.unitech-sbd.com

Unitech Global Website: http:\\www.unitech-adc.com

Regulatory Compliance Statements

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio com-

munications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications (including the antennas) made to this device that are not

expressly approved by the manufacturer may void the user’s authority to operate the

equipment.