User's Manual

Protects the product against unwanted configuration by bar code.

- Configuration with bar codes only possible before end of 1 minute timeout

(cycle repeated until no config code read within 1 minute).

Optical setup (using configuration bar codes) - Inhibit after 1 mn

<SW>744001

Transparent configuration mode

- Allows you to use your scanner to set up other products (setup commands

are transmitted to the other product but do not affect your scanner).

- Read unconcatenated configuration codes from the setup sheet to set up

another product in transparent configuration mode (not possible with EasySet

online).

Transparent configuration mode - Disable (*)

<SW>744100

Transparent configuration mode - Enable

<SW>744101