User's Manual

Scanning / Triggering - Trigger timeout (sec) - 2 (*)

<SW>70800002

Trigger activation

- Used to enable or disable hardware or emulated triggers.

- IMPORTANT: You cannot activate the trigger line if the hardware trigger is

disabled. If you are using level or pulse trigger modes, the only way to

re-activate the hardware trigger is by using online set up (ISCP terminal) or

sending an ISCP command.

Hardware and emulated triggers are disabled. The only way to turn the imager

on is by sending a decode on/decode off control command (20, 40).

Scanning / Triggering - Trigger activation - Disabled

<SW>704100

Hardware trigger ONLY is enabled.

Scanning / Triggering - Trigger activation - Hardware trigger enabled

<SW>704101

Emulated trigger ONLY is enabled.

- The trigger can only be activated by sending the emulated trigger ISCP

control command 50, 47.

Scanning / Triggering - Trigger activation - Emulated trigger enabled

<SW>704102