User's Manual

-
23
-
Chapter 4
Introduction
This chapter describes the programmable parameters, provides bar codes for
programming, and hexadecimal equivalents for host parameter programming
through SSI.
Operational Parameters
The MS916 is shipped with the factory default settings shown in Table 3-1 on
page 26. These factory default values are stored in non-volatile memory and
are preserved even when the scan engine is powered down.
Changes to the factory default values can be stored as custom defaults. These
values are also stored in
non-volatile memory and are preserved even when the scan engine is
powered down.
To change the parameter values:
• Scan the appropriate bar codes included in this chapter. The new values
replace the existing memory values. To set the new values as custom
defaults, scan the Write to Custom Defaults bar code. The factory
default or custom default parameter values can be recalled by scanning
the Set Factory Defaults bar code or the Restore Defaults bar code on
page 29.
or
• Send the parameter through the scan engine’s serial port using the SSI
command PARAM_SEND. Hexadecimal parameter numbers are shown
in this chapter below the parameter title, and options appear in
parenthesis beneath the accompanying bar codes. Instructions for
changing parameters using this method are found in Chapter 10, Simple
Serial Interface.
Parameter Menus