User's Manual
Table Of Contents
- 手冊介紹
- Regulatory Compliance Statements
- Laser Information
- LED Information
- Battery Notice
- Adapter Notice
- Hearing Damage Warning
- 全球支援
- North America
- Warranty Policy
- 1.1產品配備清單
- 1.2 產品介紹
- 1.3 規格
- 1.4 安裝與連線
- 1.5 電池充電
- 1.6 掃描器LED和嗶聲說明
- 2.1 BT HID
- 2.2 BT SPP
- 3.1 所有碼製
- 3.2 MSI / UK Plessey code
- 3.3 Code93 / Telepen / IATA
- 3.4 Interleaved 2 of 5 / Code 11
- 3.5 Industrial 2 of 5 / Matrix 2 of 5
- 3.6 Codabar
- 3.7 ABC Codabar, CX Codabar
- 3.8 Code 39 (Full ASCII/Standard) / Code 32
- 3.9 UPC-E
- 3.10 UPC-E(0)&(1) / UPC-E EXPAND
- 3.11 UPC-A
- 3.12 EAN-8
- 3.13 EAN-13 / ISSN / ISBN / ISMN
- 3.14 EAN & UCC128/Code 128
- 3.15 DataBar (RSS)
- 4.1 系統設定
- 4.2 BT Pairing
- 4.3 Output data transmit
- 4.4 BT Config
- 4.5 Beep tone, Terminator
- 4.6 掃描模式
- 4.7 條碼長度設定,同步碼,後同步碼
- 4.8 精確度調整
- 4.9 關機設定
viii
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
Adapter Notice
1. Please do not leave the power adapter in the socket when it is not
connected to your unitech product for charging.
2. Please remove the power adapter when the battery is fully recharged.
3. The bundled power adapter that comes with your unitech product is not
meant to be used outdoors. An adapter exposed to water or rain, or a very
humid environment can cause damage to both the adapter and the
product.
4. Please only use the bundled power adapter or same specification of
adapter to charge your unitech product. Using the wrong power adapter
can damage your unitech product.
* The message above only applies to the product connected to the adapter.
For the products without using the adapters, please refer to the specification of
each product.
Hearing Damage Warning
Zx.3 Warning
The warning shall be placed on the equipment, or on the packaging, or in the instruction manual and shall consist of
the following:
- the symbol of Figure 1 with a minimum height of 5 mm; and
- the following wording, or similar :
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Alternatively, the entire warning may be given through the equipment display during use, when the user is asked to
acknowledge activation of the higher level.