User's Manual
Table Of Contents
- 手冊介紹
- Regulatory Compliance Statements
- Laser Information
- LED Information
- Battery Notice
- Adapter Notice
- Hearing Damage Warning
- 全球支援
- North America
- Warranty Policy
- 1.1產品配備清單
- 1.2 產品介紹
- 1.3 規格
- 1.4 安裝與連線
- 1.5 電池充電
- 1.6 掃描器LED和嗶聲說明
- 2.1 BT HID
- 2.2 BT SPP
- 3.1 所有碼製
- 3.2 MSI / UK Plessey code
- 3.3 Code93 / Telepen / IATA
- 3.4 Interleaved 2 of 5 / Code 11
- 3.5 Industrial 2 of 5 / Matrix 2 of 5
- 3.6 Codabar
- 3.7 ABC Codabar, CX Codabar
- 3.8 Code 39 (Full ASCII/Standard) / Code 32
- 3.9 UPC-E
- 3.10 UPC-E(0)&(1) / UPC-E EXPAND
- 3.11 UPC-A
- 3.12 EAN-8
- 3.13 EAN-13 / ISSN / ISBN / ISMN
- 3.14 EAN & UCC128/Code 128
- 3.15 DataBar (RSS)
- 4.1 系統設定
- 4.2 BT Pairing
- 4.3 Output data transmit
- 4.4 BT Config
- 4.5 Beep tone, Terminator
- 4.6 掃描模式
- 4.7 條碼長度設定,同步碼，後同步碼
- 4.8 精確度調整
- 4.9 關機設定
40
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
MS912+ 使用者手冊
4.2.2.6 Remote Control
SPP REMOTE CONTROL
There are two ways to verify connection status by the host under SPP Profile.
Command Response
Host sends: CR,LF,{,A,L,},CR,LF (8 bytes)
Scanner replys: O,K,CR,LF (4 bytes)
Beeper Response
Host sends: CR,LF,{,M,1,},CR,LF (8 bytes)
Scanner replys: a short beep
SHUT DOWN
This configuration barcode will shut down the scanner immediately but still
reserve the pairing record.
SHUT DOWN
DISCONNECTION
DISCONNECT
(CLEAR PAIRING RECORD)
DISCONNECT
(KEEP PAIRING RECORD)