User's Manual
Table Of Contents
- 手冊介紹
- Regulatory Compliance Statements
- Laser Information
- LED Information
- Battery Notice
- Adapter Notice
- Hearing Damage Warning
- 全球支援
- North America
- Warranty Policy
- 1.1產品配備清單
- 1.2 產品介紹
- 1.3 規格
- 1.4 安裝與連線
- 1.5 電池充電
- 1.6 掃描器LED和嗶聲說明
- 2.1 BT HID
- 2.2 BT SPP
- 3.1 所有碼製
- 3.2 MSI / UK Plessey code
- 3.3 Code93 / Telepen / IATA
- 3.4 Interleaved 2 of 5 / Code 11
- 3.5 Industrial 2 of 5 / Matrix 2 of 5
- 3.6 Codabar
- 3.7 ABC Codabar, CX Codabar
- 3.8 Code 39 (Full ASCII/Standard) / Code 32
- 3.9 UPC-E
- 3.10 UPC-E(0)&(1) / UPC-E EXPAND
- 3.11 UPC-A
- 3.12 EAN-8
- 3.13 EAN-13 / ISSN / ISBN / ISMN
- 3.14 EAN & UCC128/Code 128
- 3.15 DataBar (RSS)
- 4.1 系統設定
- 4.2 BT Pairing
- 4.3 Output data transmit
- 4.4 BT Config
- 4.5 Beep tone, Terminator
- 4.6 掃描模式
- 4.7 條碼長度設定,同步碼,後同步碼
- 4.8 精確度調整
- 4.9 關機設定
i
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
前言
手冊介紹
感謝您選購 unitech 產品。
本手冊將介紹如何設定、操作及使用此項產品,包含基本設定介紹。
未經製造商書面許可,不得以任何形式、利用電子或機械手段(例如影印、錄音
或資訊儲存及擷取系統)重製或使用本刊物的任何部分。本手冊的內容如有變
更,恕不另行通知。
Regulatory Compliance Statements
FCC Warning Statements
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference with radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference with radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.