User's Manual
Table Of Contents
- Preface
- About This Manual
- Table of Contents
- Chapter 1
- Introduction
- Chapter 2
- Output Data Editing
- Chapter 3
- Barcode Setup Menu
- Chapter 4
- Barcode Symbologies
- Introduction
- Symbol Code Identifiers
- UPC-A
- UPC-E
- Code 39
- UPC-E1
- EAN-13/JAN-13
- Bookland EAN
- Bookland ISBN Format
- Decode UPC/EAN/JAN Supplementals
- EAN-8/JAN-8
- Code 128
- GS1-128 (formerly UCC/EAN-128)
- ISBT 128
- Convert UPC-E to UPC-A
- Convert UPC-E1 to UPC-A
- Convert Code 39 to Code 32
- Convert I 2 of 5 to EAN-13
- Trioptic Code 39
- Discrete 2 of 5
- Interleaved 2 of 5
- Coabar
- MSI
- Inverse 1D
- Postal Code Symbologies
- Composite Symbologies
- 2D Symbologies
- PDF417
- MicroPDF417
- Code 128 Emulation
- Data Matrix
- Data Matrix Inverse
- Decode Mirror Images (Data Matrix Only)
- Maxicode
- QR Code
- QR Inverse
- MicroQR
- Aztec
- Aztec Inverse
- Redundancy Level
- Security Level
- Intercharacter Gap Size
- Macro PDF Features
- Macro PDF Transmit / Decode Mode Symbols
- Transmit Macro PDF Control Header
- Escape Characters
- Flush Macro Buffer
- Abort Macro PDF Entry
- Appendix A
- Sample Barcodes
- Appendix B
- Numeric Barcodes
- Appendix C
- ASCII Character Sets
- Appendix D
- Worldwide Support
*Standard (Level)
Auto Aim
Low Power Mode
This parameter determines whether or not the digital scanner enters low power
mode after a decode attempt. If disabled, power remains on after each decode
attempt.
Time Delay to Low Power Mode
This parameter sets the time the decoder remains active after decoding. After a
scan session, the decoder waits this amount of time before entering Low Power
Mode.
Note: This parameter only applies when Power Mode is set to Low.
40
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.