User's Manual

13

Note: The 4 KB of memory buffer in the scanner can hold as many as 256 scans
based on EAN-13 barcodes. Data will be cleared out once the scanner is
turned off or running out of battery power!
Batch Mode
Batch Mode is the default memory buffer setting. For example, to set the scanner to
the Batch Mode, scan the following barcodes in the order:
Enter Group 6
In the Batch Mode, once you scan a barcode by using a scanner wirelessly
connecting to the cradle (SPP) or a host PC (HID) in a specified range, the scanner
reads out the data. When the scanner is out of range of the cradle or the host PC
and keeps scanning, the scanner will keep the data in its memory buffer until the
buffer is full; when the scanner is close to and stay within the specified range of the
cradle or the host PC, the scanner will read out the data that it read. When the buffer
is disabled and the scanner is out of range, the scanner will respond with one long
beep (low tone) and its LED indicator will become solid red and go off quickly. You
are advised to get back to range.
Inventory Mode
Inventory Mode is the mode in which the scanner keeps the scanned data in its
memory buffer but not reads out the data on the PC; the user may enable Read
Buffer to make the scanner read out the scanned data on the PC. For example, to
set the scanner to the Inventory Mode, scan the following barcodes in the order:
Bear in mind the fact that the scanner operating in the inventory mode does not read
out the scanned data but keeps the data in its memory buffer. Thus, if you want to
make the scanner output the data it scanned before, please scan the Read Buffer
barcode as shown below:
Read Buffer
Note: After you scan the Read Buffer barcode to output what you scanned before,
the barcode data is deleted from the scanner’s memory buffer.
If you do not output the barcode data, the barcode data is always kept in the
memory buffer. To erase the data from the scanner’s memory buffer, scan the
following barcodes in the order.
Buffer Erasable
E1
2

Exit
Erase Buffer
E1

Exit
1
Enter Group 6