User's Manual
Table Of Contents
- About This Manual
- Regulatory Compliance Statements
- Laser Information
- LED Information
- Battery Notice
- Adapter Notice
- Hearing Damage Warning
- Worldwide Support
- North America
- Warranty Policy
- 1.1 Package
- 1.2 Scanner & Cradle Detail
- 1.3 Specifications
- 1.4 Getting Started
- 1.5 Battery Charging
- 1.6 LED Indicator / Beeper Sequence
- 2.1 Flow Chart
- 2.2 Loop of Programming
- 2.3 Factory Default Settings
- 2.4 Main Page of Configuration
- 3.1 SymboIogies Selection
- 3.2 UPC/EAN/JAN Parameters
- 3.3 Code 39 Parameters
- 3.4 Code 128 Parameters
- 3.5 Interleave 25 Parameters
- 3.6 Industrial 25 Parameters
- 3.7 Matrix 25 Parameters
- 3.8 CODABAR/NW7 Parameters
- 3.9 Code 93 Parameters
- 3.10 Code 11 Parameters
- 3.11 MSI/PLESSEY Code Parameters
- 3.12 Code 2 of 6 Parameters
- 3.13 LCD25 Parameters
- 3.14 Telepen Parameters
- 3.15 GS1 Databar
- 3.16 Bar Code ID
- 4.1 Interface & Reading Mode Selection
- 4.2 Communication Parameters
- 4.3 Language Selection
- 4.4 Reading Level
- 4.5 Accuracy
- 4.6 Buzzer Beep Tone
- 4.7 Sensitivity of Continuous Reading Mode
- 4.8 Reverse Output Characters
- 4.9 Setup Deletion
- 4.10 Setup Insertion
- 4.11 PAN Configuration
45
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
4.7 Sensitivity of Continuous Reading
Mode
A. Quick Setting
Fast *
Slow
B. Same Code Delay Reading Interval
Following code sequences represent the length of time before a barcode can
be rescanned at continuous and flash reading mode. The value can be
defined from 1-50 and they represent 100ms to 5 seconds in100ms interval.
Default value is 3 (0.3 seconds).
To setup same code delay reading interval:
1. Scan the "Begin" label
2. Go the Numeric Bar Codes in Appendix A, Scan label(s),that represents
the same code delay reading interval. They are ranged form 1-50.One step
is represented 0.1second.So the interval is from 0.1 to 5 seconds.
3. Scan the "Complete" label
Repeat the steps 1-3 to set time out of same symbol
1. Begin 3. Complete
2. Numeric Bar
Codes (Appendix A)