User's Manual
Table Of Contents
- About This Manual
- Regulatory Compliance Statements
- Laser Information
- LED Information
- Battery Notice
- Adapter Notice
- Hearing Damage Warning
- Worldwide Support
- North America
- Warranty Policy
- 1.1 Package
- 1.2 Scanner & Cradle Detail
- 1.3 Specifications
- 1.4 Getting Started
- 1.5 Battery Charging
- 1.6 LED Indicator / Beeper Sequence
- 2.1 Flow Chart
- 2.2 Loop of Programming
- 2.3 Factory Default Settings
- 2.4 Main Page of Configuration
- 3.1 SymboIogies Selection
- 3.2 UPC/EAN/JAN Parameters
- 3.3 Code 39 Parameters
- 3.4 Code 128 Parameters
- 3.5 Interleave 25 Parameters
- 3.6 Industrial 25 Parameters
- 3.7 Matrix 25 Parameters
- 3.8 CODABAR/NW7 Parameters
- 3.9 Code 93 Parameters
- 3.10 Code 11 Parameters
- 3.11 MSI/PLESSEY Code Parameters
- 3.12 Code 2 of 6 Parameters
- 3.13 LCD25 Parameters
- 3.14 Telepen Parameters
- 3.15 GS1 Databar
- 3.16 Bar Code ID
- 4.1 Interface & Reading Mode Selection
- 4.2 Communication Parameters
- 4.3 Language Selection
- 4.4 Reading Level
- 4.5 Accuracy
- 4.6 Buzzer Beep Tone
- 4.7 Sensitivity of Continuous Reading Mode
- 4.8 Reverse Output Characters
- 4.9 Setup Deletion
- 4.10 Setup Insertion
- 4.11 PAN Configuration
1. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
2. This device complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. To maintain compliance with FCC RF
exposure requirements, avoid direct contact to the transmitting antenna
during transmitting.
3. Any changes or modifications (including the antennas) made to this
device that are not expressly approved by the manufacturer may void the
user’s authority to operate the equipment.
FCC Label Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Canadian Compliance Statement
This Class B Digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe B respecte les exigences du Reglement
sur le material broilleur du Canada.
ii
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd