User's Manual

Unitech Part Number: 400412

1.3.4. DIAG - Diagnostics

The HT580L has a built-in diagnostics program to test the terminal's hardware. The test routines are

data destructive. Therefore, before running the diagnostic program, make sure you back up the data

in the HT580L.

Note : When a H/W or S/W service has been made on the PT630, such as maintenance, repair or upgrade, it

is strongly recommended to run the diagnostic program.

At the Supervisor Mode menu:

1. Press 7 (7.DIAG), then LCD will display the diagnostic menu as

shown on the left. Select 1-8 to run the desired diagnostic routine

1. VER : Get F/W version for HT580L and Decoder.

2. SCAN : test bar code input by scanning bar code labels. Press ESC key to return to the

diagnostics menu.

3. LCD : Darken the dots of the LCD screen and cycle power to the LCD backlight to check

if the LCD functions OK

4. COMM : Connect to PC’s communication testing program to test USB/RS232

communication

5. PWR : Testing Battery power

6. KEY : Test every key response

7. RTC : Show Current time/date is displayed

8. MEM : Test RAM condition

Note : Please refer to Service manual for more detail information.

1. VER 2. SCAN

3. LCD 4. COMM

5. PWR 6.KEY

7. RTC 8.MEM