Owner manual

Sierra Programming Reference Manual 5

3.1 Site

Figure 4. Site Information Screen

The Site Configuration screen allows you to provide unique identification for your site, set up credit and gift

card processing, chose your accounting close time, and to enable verbose logging on the Sierra

Management Application. From the Summary screen, click the Setup tab and then click Site on the left

frame to display the Site Configuration screen. Click Edit next to the site name.

1. Enter the Site Name. This field is limited to 25 characters. The site name will appear at the top of

the Sierra Management pages and on the system reports.

2. If you wish to do so, click Address and enter the site address and contact information.

3. Enter the Site ID number. The default is set to one. The site ID number is shown in alert notifications

sent via text message to identify the site from where the alert is sent.

4. Select an accounting ‘close’ time. The default is set to 11:59pm.

5. If your region uses Daylight Savings Time and if you would like the server to automatically update

to Daylight Savings Time, select Enable Daylight Savings.

6. If you wish to run debugging logs, click Enable Verbose Logging. This should normally be disabled

(unchecked) and only enabled when instructed to do so by a Unitec customer service technician.

7. For server options, choose one of the following:

 Standard – for standard car washes. You will use this option to configure the Remote Code

POS4000, if applicable.

 External – for sites with WashSoft, Auto Pilot, or other 3

party servers.