Manual

POS4000
Document Number: POS4007 11
Document Title: POS4000/V2 WSII Operations Manual
2.3 POS4000 Function Lines/Car Wash Features
The function control lines used to start the specific car wash features purchased by the customer
are identified as "function lines 1 - 8". The use of these lines is dependent on the specific
software program in the POS4000 console. The uses of the function lines are given in the table
on the following page by the type and number of program. To determine your POS4000
configuration, check the system configuration report
Table 6. Function Lines
Interface Function Line
# of
Programs
1 2 3 4 5 6 7 8
Multi-pulse
*
Pulsed Opt 1 Opt 2 Opt 3 Opt 4
Opt
5
Opt 6 Opt 7
1 Program Prog 1 Opt 1 Opt 2 Opt 3 Opt 4
Opt
5
Opt 6 Opt 7
2 Programs Prog 1 Prog 2 Opt 1 Opt 2 Opt 3
Opt
4
Opt 5 Opt 6
3 Programs Prog 1 Prog 2 Prog 3 Opt 1 Opt 2
Opt
3
Opt 4 Opt 5
4 Programs Prog 1 Prog 2 Prog 3
Prog
4
Opt 1
Opt
2
Opt 3 Opt 4
5 Programs Prog 1 Prog 2 Prog 3
Prog
4
Prog
5
Opt
1
Opt 2 Opt 3
6 Programs Prog 1 Prog 2 Prog 3 Prog
4
Prog
5
Prog
6
Opt 1 Opt 2
7 Programs Prog 1 Prog 2 Prog 3 Prog
4
Prog
5
Prog
6
Prog
7
Opt 1
8 Programs Prog 1 Prog 2 Prog 3 Prog
4
Prog
5
Prog
6
Prog
7
Prog
8
* In multi-pulse operation, Function line 1 is pulsed 1, 2, 3 etc. times to issue different carwash programs.

Note:
If your configuration has fewer than the maximum options (as indicated in the table
above), then the upper function lines are not used. For example, if you have 3
programs and 3 options then lines 7 and 8 are not used.