Manual

POS4000
Document Number: POS4007 81
Figure 7. Loading the Printer Paper
7.1.5 Actuating the Print Functions
1. Be sure that a paper role is properly loaded.
2. Confirm that the ribbon cassette is properly installed and turn the power switch off.
3. Turn the power switch on while pressing the LF switch, and then release the LF switch
after the self-test has begun.
In the above operation, the self-print function will stop automatically when completed. However,
the self-print function will not operate without paper.
7.1.6 Alarm and Paper Near-End Detection
This printer has the paper near-end sensor to stop the operation when the paper comes to near-
end, sending out both BUSY and FAULT signals. This status is indicated by the SEL/ALARM
lamp blinking at an interval of one second.
If the printer goes alarm, the printer stops printing out and outputs FAULT signal OFF-LINE
state. This status makes the SEL/ALARM lamp blink at an interval of one quarter of a second.
Document Title: POS4000/V2 WSII Operations Manual