Manual

EZTRAK
Document Number: EZT1001 4
Document Title: EZ Trak Installation Manual
2 Installation
2.1 Mechanical Installation Tools
The following tools are recommended for the typical mechanical installation of this EZ Trak
unit:
 6” inch or longer ratchet extension (for optional straight base)
 ¾” inch deep well socket and socket wrench
 Small, thin blade, flat-tip screwdriver
 Hammer drill
 ½” Concrete hammer drill bit
 Hammer
 Dual-plane Level
 50’ foot tape measure
2.2 Electrical Installation Tools
 Small, thin tipped, straight screwdriver (1/8” tip, for green Phoenix connectors)
 Wire strippers (capable of handling 10-22 AWG wire)
 Cable or wire tie wraps
 Diagonal cutters
 Needle nose pliers
 5/16” nut-driver
 ¼” nut-driver
 Phillips-head and flat-head screwdrivers