Manual

EZTRAK
Document Number: EZT1001 8
2.4 Electrical Installation
2.4.1 Wiring for the Interface Board
Figure 6. Interface Board Connections
Notes on installation:
1. The carwash PLC activation voltage is applied to the program relay output in
order to activate the carwash.
2. The Wash-In-Use signal cannot exceed 110 VAC.
3. The heater is active when the red light (D2) is on.
2.4.2 Wash Outputs
1. Locate the small, thin-tipped screwdriver, and the EZ Trak power
distribution board, which is located on the inside of the EZ Trak front
Document Title: EZ Trak Installation and Operations Manual