User manual

Procedure for
inflating tyres
Procedure for inflating
balls and airbeds
Work light
Cleaning instructions
Technical specifications
Disposal instructions
YC2211B Circuit diagram
• Positionthetyresothatthevalveisaslowaspossible.
• Screwtherubberhoseconnectortothetyrevalve.Ifthetyreiscompletelyemptyofair,
thevehicleshouldberaisedalittlewithajacksothatthereisnoadditionalcounter-
pressure acting on the empty tyre.
• Puttheplugintothecigarettelighter(12Volt).Thecompressorisnowreadytooperate.
• Youcansettheunitofmeasurementforpressurewiththe„SET“button(BAR,PSI,KG/
CM³,KPA)
•Setthedesiredairpressurewiththe„+“and„-“buttonsandstartthecompressorwith
the„COMPRESSORON“button.Thedevicewillswitchoffautomaticallywhentheset
pressure is reached. The inflation process may be interrupted by pressing the
„COMPRESSOROFF“button.
• Afteruse,taketheplugbackoutofthecigarettelighter.
• Selecttheappropriateadapterandconnectthecompressortotheitemtobeinflated.
• Putthepluginthecigarettelighter(12Volt).Thecompressorisnowreadytooperate.
• Youcansettheunitofmeasurementforpressurewiththe„SET“button(BAR,PSI,KG/
CM³,KPA)
• Setthedesiredairpressurewiththe„+“and„-“buttonsandstartthecompressorwith
the„COMPRESSORON“button.Thedevicewillswitchoffautomaticallywhentheset
pressure is reached. The inflation process may be interrupted by pressing the
„COMPRESSOROFF“button.Avoidoverinflatingtheitembeinginflatedasthismay
cause it to burst!
• Afteruse,taketheplugbackoutofthecigarettelighter.
• Toswitchtheworklightonandoffpleasemovetheswitchtothe„LIGHTON“or
„LIGHTOFF“position.
• Donotlookdirectlyintotheworklight.
• Ifthehousingbecomesdirty,wipeitwithadampcloth.Donotimmersethedevicein
water.
• Operatingvoltage: 12VDC
• Maximumpressure: 10bar
• Airflowrate: 22litres/min
• Power: 0.096–0.120kW,0.214kg
• Rotationspeed: 16,000rpm
• Noiselevel(wheninflating): <85dB
At the end of its working life do not dispose of this product in the domestic refuse
butatthelocationssetupforthereturnofusedelectricalequipment.
DC12V
IC PCB for
pressure
gauge
Pressure
sensor
Hose
PCB
+
K1
K2
2W100Ω
–
M
10945_Bed_A5_131218.indd 5 27.01.14 13:39