User guide

76-110-0887/0, Issue 1

5-10

• Enter the number of voice channels on the card.

• Enter the number of RDSP on the card (1 for every 4 ports).

4. Finally, confirm the information and repeat for each card.

5. Reboot the system after completion of this process.

5.4.14 Define modem

1. Select which com port will be used for remote administration.

For Com1 press 1, Com2 press 2, etc.

2. Fax ports can be defined as remote administration ports when

setting up fax ports, below.

5.4.15 Configure Fax

Select the configure fax option from the T3adm menu -- under Extra

stuff.

The Fax installation has two steps:

1. Run fax setup – following the steps on the screen to initialize the

fax engine.

2. Add a modem – the system will ask for a device name.

• If you are using a US Robotics modem (single port modem),

the device is ttyS3.

• If you are using a multi port modem, the device names are:

3. Follow the instructions for adding a modem --

press Enter -- to select the default entry for each field.

4. Select either:

• option 4 -- to view the available modems,

• option 3 -- to remove a modem.

Before exiting from the fax configuration, the system will ask you if

you want to use the fax port as a port for remote access.

no. name port

i. ttyM1a port 1

ii. ttyM1b port 2

iii. ttyM1c port 3

iv. ttyM1d port 4

v. ttyM1e port 5

vi. ttyM1f port 6

vii. ttyM1g port 7

viii. ttyM1h port 8