User guide

Section 5: SYSTEM ADMINISTRATION
5-9
5.4.11 Import/Export Data Base
You can import or export a mailbox, class of service or department
data base. You can then upload this information on a different ma-
chine and put it back on the current system.
• Select the desired mailbox, COS or department.
The system will request a floppy disk,
or
it will save it in a temporary location.
5.4.12 Select PBX
e
maGEN
has a built in library of PBXs from which you can choose.
1. Simply select the PBX type
and
2. Restart
e
maGEN
(software only, reboot is not necessary).
The values for the PBX you selected will appear on the PBX
page of the Controller.
5.4.13 Configure voice card
To add or remove voice cards to/from the system, you will need to
use the configure voice card option from
e
maGEN
T3. Each time
you access this option, you will define all voice boards in the system.
You will need to specify the following information:
1. the address of each card in the system.
The first card (ports 1 through 4) is by default on address 300.
The next are 301, 302 etc.
Refer to the Brooktrout Hardware installation guide for more
information on setting up the address jumpers on the card.
After entering the address of the card, the system will show you
the card configuration:
• the firmware version
• number of voice channels on the card
• number of DSP’s.
2. If the information shown is incorrect, type no.
3. If you typed no, above, you will be able to set the following
parameters:
• Type the number of the firmware you wish to select
-- either 1 or 2, below:
1. firmvp.std is used in US cards (Quartet, RDSP 432).
2. firmvp.van is used in European cards such as the
Volare EU4 and PCI cards from the Vantage family.