User guide

Section 5: SYSTEM ADMINISTRATION
5-5
5.4
e
maGEN
T3 Adm
The
e
maGEN
T3adm is an administration and setup utility. It will en-
able you to change IP configuration, start and stop
e
maGEN
, shut-
down the system and change low level
e
maGEN
parameters.
To run the
e
maGEN
T3adm program, proceed as follows.
5.4.1 Logging in – “telnet”
To run the
e
maGEN
T3adm program you need to be logged on to
e
maGEN
using telnet.
To run telnet:
1. open a command prompt in windows and type:
telnet
e
maGEN
IPAddress
where
e
maGEN
IPAddress is the name or IP address of the
e
maGEN
machine.
For example:
telnet 192.168.0.100
A communication session will start and the Linux prompt for user
name and password will appear.
2. Enter the user name and password (this entry is case sensitive).
• The default user name is: T3adm
• The default password is: tenecs
You will then be at the Linux command prompt.
Telnet can only be used over IP. If you do not have an IP connection
established, you can use HyperTerminal over a null modem cable or
a standard modem to connect to
e
maGEN
and run
e
maGEN
T3adm.
To exit from telnet:
• type exit twice
or
• simply close the command line window.
5.4.2
e
maGEN
T3adm options
• Start the
e
maGEN
T3adm program by typing
e
maGEN
T3adm
at the prompt.
You will be prompted to enter the super user password.