User guide

76-110-0887/0, Issue 1
5-2
• create a direct PC-to-PC connection with a crossover data cable,
as shown on the right, in Figure 5-1, below.
Figure 5-1 Crossover Cable Diagram
A data connection will ensure that TCP/IP protocol is running and will
enable ftp, web browsing and telnet.
For a data connection, you will need to know the IP address and sub-
net mask of
e
maGEN
.
5.2.2 Modem connection
e
maGEN
is configured to accept remote administration via modem.
Make sure a modem is connected or installed on
e
maGEN
, and a
telephone line is connected to the modem. The modem is set to an-
swer automatically by default.
e
maGEN
is equipped with a built-in remote access mechanism.
You can network to it using windows dial-up networking.
To connect to an
e
maGEN
system, you will need to create a dial up
account (as specified below) and then login to the system.
A. Connecting to a remote
e
maGEN
1. Double click the dial-up account you create (as defined in the
two sections below)
2. Enter the user name and password of
e
maGEN
-- both are
"tenecs" by default.
3. Click “Dial”.
A window should pop-up once a connection is established.
4. Enter the login name -- "tenecs", and press Enter.
5. Enter the password -- "tenecs", and press Enter.
6. Once you have logged in, type slirp -P, and press Enter.
The system will print out its current ip address (default is
192.168.0.100), and other system information.