User guide

Section 3: INSTALLATION
3-7
Table 3-1 I/O port jumper settings
3.8.2
e
maGEN
-PC voice mail card insertion
You must insert the
e
maGEN
-PC cards into the
e
maGEN
-PC.
Cards can be placed in any PCI slot.
WARNING
Turn off and disconnect power to the PC,
before starting any card insertion proce-
dure.
The physical act of installation is the same as for any other PC card.
This procedure is not described here, since it may vary from one PC
model to another. Refer to your PC manual for card installation
instructions.
CAUTION
The
e
maGEN
-PC printed circuit cards
contain components that are sensitive to
static electricity and should not be handled
except as needed to avoid any problem
with electrostatic discharge. Hold the card
by its outer edges. The use of a wrist
ground strap is recommended, as shown in
Figure 3-1, below.
Card
no.
MSB jumpers LSB
9876543210
1 OOXXXXXXXX
2 OOXXXXXXXO
3 OOXXXXXXOX
4 OOXXXXXXOO
5 OOXXXXXOXX
6 OOXXXXXOOO
7 OOXXXXXOXX