User guide

76-110-0887/0, Issue 1
3-6
e
maGEN
, on one, two or three OCD cards;
• inserting the OCD card(s), with MIM(s) mounted, in the
unit
e
system cabinet.
• Connection between
e
maGEN
and the
unit
e
system;
Section 3.9.3 and Section 3.9.4, below, describe:
• making the data connections between:
-- the first and, if present, fourth or last,
e
maGEN
-PC card --
and the OCD card(s) in the
unit
e
system cabinet;
• making the audio connection between:
-- each
e
maGEN
card in the
e
maGEN
-PC
-- and the OCD block in the
unit
e
system MDF, via the audio
junction box.
3.8 INSTALLING e
maGEN
VOICE MAIL CARDS
IN THE
e
maGEN
-PC
3.8.1
e
maGEN
voice mail card jumper settings
One or more of the following three types of
e
maGEN
-PC four tele-
phony port, single slot, half-sized, ISA compatible voice processing
cards, manufactured by Brooktrout Technology, are used, in order to
set up your system.
Depending on which of these cards are to be used in your system,
refer to the corresponding Brooktrout Technology Hardware instal-
lation Guide brochure:
• Prelude Quartet card -- Part Number 934-011-40, Revision 1.00;
• Vantage Volare card -- Part Number 934-009-90, Revision 1.00;
• RDSP 432 card -- Part Number 73-00-0014, Revision 1.00.
You should comply with all instructions in the brochure before insert-
ing the respective type of
e
maGEN
-PC card into the
e
maGEN
-
PC.
The Quartet board has fixed settings as card no. 1, for which no
juper setting is required. For junper settings of all other cards, follow
the required jumper settings shown in Table 3-1, below, for each of
the respective cards. In this table: O = open circuit X = closed cir-
cuit.