User guide

3-1
Section 3
INSTALLATION
3.1 GENERAL
Sections 3.2 through Section 3.6, below, describe planning and
component requirements for the installation of the
e
maGEN
sys-
tem, .
Section 3.7 through Section 3.16, below, describe the procedure for
installing the physical components of
e
maGEN
within the
e
ma-
GEN
-PC, and the connections between the
e
maGEN
-PC and the
unit
e
system.
Section 3.17 through Section 3.21, below, describe post-installation
checkout and troubleshooting procedures for
e
maGEN
.
3.2 INSTALLATION PLANNING
Your
unit
e
system must be fully installed and operational before
you can install
e
maGEN
. See the
unit
e
family of systems Installa-
tion manual for full details of the required installation procedure.
Due to protocol changes,
e
maGEN
requires that at least
unit
e
System Software Release SB7, DB7 or LB7 be operating in your
system.
The
e
maGEN
installation sequence is as follows:
• Hardware installation, as described in Sections 3.7 through Sec-
tion 3.16, below;
• Software installation, as described in Section 5 and Section 6,
below;
• Post-installation checkout, as described in Section 3.17 through
Section 3.21, below;
•
e
maGEN
system programming and administration, as
described in Section 5 through Section 19, below;