User guide

76-110-0887/0, Issue 1
9-14
9.11 INTEGRATION PARAMETERS
Figure 9-2 PBX --> Integration screen
The following parameters are used in Full DTMF Integration only. If
full integration mode is checked,
e
maGEN
would expect to receive
Touch Tones from the PBX. It will then handle the call according to
the table below.
Full integration support
This field tells
e
maGEN
whether or not to expect information from
the PBX. Such information, in the form of DTMF strings or RS232
Action:
Enter the desired PBX sequence to signal
disconnect.