User's Manual

While in the search mode, the remote search icon will be constantly displayed.
If you have more than one thermo-hygrometer sensor (up to eight thermo-hygrometer sensors are
supported), the display will automatically toggle between sensors until all sensors have reported in.
Note: The power adapter is intended to be correctly oriented in a vertical or floor mounted position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
Figure 13
Note: If the power adapter is plugged in, AC ON will display in the time area for three seconds when
powered up. Conversely, if the power adapter is not plugged in, AC OFF will be displayed.
4.4.3SensorOperationVerification
The following steps verify proper operation of the sensors prior to installing the sensor array.
1. Verify proper operation of the rain gauge. Tip the sensor array back and forth several times. You should
hear a “clicking”sound within the rain gauge. Verify the rain reading on the display console is not reading
0.00. Each “click”represents 0.01 inches of rainfall.
2. Verify proper operating of the wind speed. Rotate the wind cups manually or with a constant speed fan.
Verify the wind speed is not reading 0.0.
3. Verify proper operation of the indoor and outdoor temperature. Verify the indoor and outdoor temperature
match closely with the console and sensor array in the same location
(about 3m apart). The sensors should be within 2°C (4°F) (the accuracy is ±1°C/2°F). Allow about 30
minutes for both sensors to stabilize.
4. Verify proper operation of the indoor and outdoor humidity. Verify the indoor and outdoor humidity
match closely with the console and sensor array in the same location (about 3m apart). The sensors should
be within 10% (the accuracy is ± 5%). Allow about 30 minutes for both sensors to stabilize
5.WeatherStationInstallation