User's Manual

DIP SWITCH
1 2 3 4
FUNCTION
DOWN DOWN DOWN --- Channel 1
DOWN DOWN UP --- Channel 2
DOWN UP DOWN --- Channel 3
DOWN UP UP --- Channel 4
UP DOWN DOWN --- Channel 5
UP DOWN UP --- Channel 6
UP UP DOWN --- Channel 7
UP UP UP --- Channel 8
--- --- --- DOWN °F
--- --- --- UP °C
Table 1
4. Insert two AAA batteries.
5. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and then flash
once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.
6. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on the display,
as shown in 10.
Figure 10
(1)
temperature
(2) temperature units (
°F vs. °C)
(3) channel number
(4) relative humidity
7. Close the battery door. Make sure the gasket (around the battery compartment) is properly seated in its
trace prior to closing the door. Tighten the set screw.