User's Manual
Page 8
temperature match closely with the console and sensor array in the same location (about 10'apart). The
worst case sensor accuracy should be within 4°F worst case (the accuracy is ±2°F). Allow about 30
minutes for both sensors to stabilize.
• Verify proper operation of the indoor and outdoor humidity. Verify the indoor and outdoor humidity
match closely with the console and sensor array in the same location (about 10'apart). The worst case
sensor accuracy should be within 10% (the accuracy is ± 5%). Allow about 30 minutes for both
sensors to stabilize.
9.1 RestoreFactoryDefault
To restore the console to factory default (WiFi network ,Weather server and Units):
1. Remove the DC power.
2. Press and hold the RF button and plug the DC power back in.
3. Wait three seconds after plug DC power to let go of the RF button.
9.14 WiFiConnectionStatus
When the console successfully connects to your Wi-Fi router, the Wi-Fi LED induct will light on. If
the Wi-Fi signal is not stable or the receiver is trying to connect to the router, the Wi-Fi LED
will
flash. If the Wi-Fi LED
is off, it means the console is not connected to the Wi-Fi router.
Note: If you own a dual band router (2.4 GHz and 5.0 GHz), make sure you connect to the 2.4 GHz band,
otherwise it will fail to connect the weather station to WiFi.
9.15 TimeServerSyncStatus
After the console has connected to the internet, it will attempt to connect to the USA's NIST internet time
server to obtain the time. The time will automatically synchronize to the internet per an hour.
7 WiFiandInternetServices
The WS0100 includes a WiFi chip that connects to the 2.4 GHz band on your router and sends data
automatically once per minute to our cloud services, AmbientWeather.net.
AmbientWeather.net captures, stores and sends data to other services, such as WeatherUndergroud.com,
PWSWeather.com, IFTTT, Amazon Alexa, Google Home and more. Application Programming Interface
(API) is available for programmers and third party programmers.