User's Manual

Page 7
otherwise the outdoor sensor search mode will be terminated.
While in the search mode, the receiver search RF LED
will be remain flashing.
Note: The power adapter is intended to be correctly oriented in a vertical or floor mounted position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
Figure 51
Note: Indoor use only. Use a screw or nail (not included) to affix the WIFI receiver to the wall, as
shown in Figure 51.
8.3 SensorOperationVerification
The following steps verify proper operation of the sensors prior to installing the sensor array.
• Verify proper operation of the rain gauge. Tip the sensor array back and forth several times. You should
hear a “clicking” sound within the rain gauge. Verify the rain reading on the display console is not
reading 0.00. Each “click” represents 0.01 inches of rainfall.
• Verify proper operating of the wind speed. Rotate the wind cups manually or with a constant speed fan.
Verify the wind speed is not reading 0.0.
• Verify proper operation of the indoor and outdoor temperature. Verify the indoor and outdoor