System information
26
CHANGING THE TV SETTINGS
SD settings
This screen allows you to specify the type of
standard-denition (SD) TV you have connected
to your set-top box. Making the correct settings at
this screen will ensure you have the best picture
available.
From the Setup menu (see page 24), highlight ‘TV
settings’ then press OK. Then highlight ‘SD settings’
and press OK. The SD settings screen appears (see
right).
Use U D to highlight the item you want to change,
then use L R to select the setting.
Use the table below to help you choose the
settings you want. The factory settings (when your
set-top box is new or if you reset your set-top box
as described on page 28), are shown with a star *
against them.
Item Settings Comments
TV screen format *4:3
16:9
If you have a widescreen TV, set this to ‘16:9’. If you have a standard
TV, set it to ‘4:3’.
Scaling Auto
*LetterBox
Pan & Scan
Your choice of setting aects widescreen transmissions shown
on standard (4:3) TVs. With ‘LetterBox’ the whole of a widescreen
transmission displays, but the picture does not ll the screen. With
‘Pan & Scan’, the screen is lled, but only part of the widescreen
transmission displays.
SCART video *CVBS
RGB
If you set YPbPr video “On” (see page 27), SCART video is
automatically set to “CVBS”. If your TV is RGB-compatible, but not
connected by component video leads, you can select the setting
“RGB” to improve picture quality.
SCART AV control *On
O
If this is set ‘On’, your TV should switch automatically to show
digital channels from your set-top box on the TV screen, whenever
your set-top box is on. You may prefer to use your TV’s remote
control to select the appropriate AV channel on your TV (in which
case, set ‘O’).
USING THE SETUP MENU
To test changed conguration settings, before you
save them, press the red button. Your set-top box
will temporarily display the eect of any changes.
When you have made the changes you wish to
make, press OK. If you do not want to save your
changes, press the EXIT button.