System information

9
GETTING STARTED
INSERTING YOUR REMOTE
CONTROL’S BATTERIES
Insert the two batteries into your remote control.
Make sure you insert them the correct way round,
as shown by the + and – symbols in the battery
compartment.
REPLACING THE BATTERIES IN YOUR
REMOTE CONTROL
• Always replace both batteries at the same time.
• Please dispose of batteries in an
environmentally-friendly way.
• Used alkaline batteries must never be thrown
into a re.
SWITCHING ON YOUR SETTOP
BOX
When you have connected your set-top box to
the mains supply, its indicator light, just below the
Standby button (S), will light up.
If your set-top box is in standby, the light will be red;
if your set-top box is out of standby, the light will
be blue.
If the indicator light is red, switch on your TV, then
press the Standby button (S) on the front panel of
your set-top box.
Whenever you are not using your set-top box, you
should put it into standby by pressing the Standby
button (S).
SWITCHON CHANNEL SETTING
The factory setting for your set-top box is for it to
always tune to the last-viewed channel when you
bring it out of standby. You can change this setting,
so that your set-top box tunes to a specic channel
instead (see page 31).