Installation Guide

1. The power cord is equipped with a three-prong (grounding) plug which

mates with a standard three-prong grounding wall receptacle to minimize

the possibility of electrical shock hazard from the range.

2. All cord connected appliances shall include instructions relative to location

of the wall receptacle and a warning to the user to disconnect the electrical

supply before serving the appliance.

3. Where a standard two-prong wall receptacle is encountered, it is the

responsibility and obligation of the customer to have it replaced with a

properly grounded three-prong wall receptacle. Do not cut or remove the

grounding prong from the power cord.

Label all wires prior to disconnection when servicing

controls. Wiring errors can cause improper and

dangerous operation. Verify proper operation after

servicing.

CONNECTING RANGE TO GAS SUPPLY

1. Install a manual gas line shut-off valve in the gas line in an easily accessed

location outside the range, in the gas piping external to the appliance for

the purpose of turning on or shutting off gas to the appliance.

2. Install a male 1/2” are union adapter to the 1/2” NPT internal thread elbow

at the inlet of regulator. On models equipped with standard twin burners,

install the male pipe thread end of the 1/2” are union adapter to the 1/2”

NPT internal thread at inlet of pressure regulator. Use a wrench on the

regulator tting to avoid damage.

3. Install a male 1/2” or 3/4” are union adapter to the NPT internal thread of

the manual shut-off valve, taking care to secure the shut-off valve to keep

it from turning.

4. The gas supply pressure for checking the regulator setting is 6 in.w.c.

(Natural Gas) and 11 inch.w.c. (LP gas) connect exible gas line connector

to the regulator on the range. Position range to permit connection at the

shut-off valve.

5. When all connections have been made, make sure all range controls are in

position and turn on main the gas supply valve.

6. Leak testing of the appliance should be conducted according to the

manufacturer’s instructions.

ELECTRICAL GROUNDING

CAUTION