Warranty

UNIQUE UGP 3
19
5. Turn fridge upside down and proceed to slide the top of the freezer door
onto the top hinge pin.
6. Insert the lower hinge into the bottom hole of the fridge door, also including
any round spacers that may have been present on the hinge pin when you
removed the hinge. Line up the side of the fridge door with the cabinet
before tightening hinge to bottom of cabinet. Start to fasten the lower hinge
to the bottom of the appliance. Tighten all screws once you’re sure
everything is lined up. Some screws will be self-tapped in bottom of
appliance.
7. The door handle (C) can be mounted to the other side of the door. Two
screws.
Note: As the door gasket gets pressed-in during shipment, after reversing the door the
gasket might have to be reset. If there is a gap between the cabinet and the door gasket, set
the gasket by gently pulling it out to seal the gap. If necessary, you are recommended also
to use the hair dryer to warm the gasket in hot water to get rid of the gap.
Changing the Heating Element
The heater which is fitted inside the boiler casing (B), of the refrigerator unit, can be
changed as follows:
1. Pull the power cord out of the wall socket.
2. Remove the cover (C).