Installation Guide

UNI QUE UGP 2 4 G
11
The appliance and its individual shut-off valve must be disconnected from the gas
supply piping system during any pressure testing of that system at test pressures in
excess of
psig.
The appliance must be isolated from the gas supply piping system by closing its
individual manual shut-off valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 psig.
Installation
It is the responsibility of the installer to make certain that the range is properly
adjusted at the time of installation. Situations caused by improper adjustments or
improper installation are not covered under the warranty. Any expenses incurred due
to such situations will not be paid by the manufacturer of the appliance.
Connecting gas to range
This range is designed to operate at a pressure of 4” of water column on natural gas
(NG) or 10” of water column on propane gas (LPG).
Make sure you are supplying your range with the type of gas for which it is designed.
This range comes equipped from the factory equipped for use with LPG
(propane). This range is convertible for use on natural gas (NG) also. (natural gas
• Gas line shut-off valve
• To reduce the possibility of gas
leaks, apply Teflon tape or a thread
compound approved for use with
LP or Natural gases to all threaded
connections.
• Connect the supplied
” threaded
pipe to the units regulator located on
the back left of the unit. We suggest
using a
” female to 3/8” male flare
adaptor on the end of the
”
threaded pipe supplied.
• Use a flexible appliance connector to
connect your gas supply to the
appliance. A 3 foot length is
recommended for ease of
installation but other lengths are
acceptable. Never use an old
connector when installing a new
range.
• Check for leaks using a leak detector
or soapy water with a recommended
ratio of 75% water, 25% dish
washing soap.