Installation Guide
26
Knobs
Pull forward on the knobs to remove them. Wash in a water solution with a mild
detergent mix. Do not use an abrasive cleaner or any abrasive action. Abrasive action will
scratch away the knob markings.
If the knobs become loose on the valve stem, spread the valve stem slightly with a small
screwdriver.
Using Commercial Oven Cleaners
Commercial oven cleaners may be used on porcelain lined ovens; however, many cleaners
are very strong, and it’s essential to follow instructions carefully. Be sure to wear rubber
gloves to protect your hands.
After using such cleaners, thoroughly rinse the oven with a solution of 1 tablespoon
vinegar to 1 cup of water. Oven cleaners can coat or damage the thermostat sensing
device (the long tube in the oven) so that it will not respond to temperature accurately. If
you use an oven cleaner, do not let it contact the sensing bulb, or any chrome, aluminum,
or plastic part of the range.
Do not apply or allow the cleaner to come in contact with any parts or surfaces
other than the oven interior.
Grates, Main Tops, Surface Burners and Sealed Burners
The grates are made of porcelain coated steel. These materials can be cleaned at the sink
with detergent or soap-filled scouring pads. Do not be alarmed when the grate loses its
shining finish. The heat from the burners will cause the grates to lose their shining finish.
NOTE: Top burner grates must be seated in the proper position with the retainer lug in
the hole provided for it. This will prevent the burner grate from rotating or tilting. To
remove the range top on standard models, first remove the grates. Lift up the front of
the main top, then grasp the top at each side and pull it toward you. On sealed burner
models, you must first remove the burner grates and burner heads.
When removing the burner head/s, the ignitor wire must be disconnected and secured in
some fashion, paper clip, tape, etc., to keep it from falling through the access hole in the
main top. Never immerse the ignitor in water. This can cause ignition problems. Clean
the burner head with a non-abrasive soap filled scouring pad, rinse thoroughly and dry
completely before reassembling. Burner heads can be dried in the oven at about 350
degrees Fahrenheit or in the dishwasher on the dry cycle. If there is a need to remove the
main top, remove the four (4) attachment screws shown on page 13. After adjustment or
cleaning, replace all parts to their original position. Care should be taken when connecting
the ignitor wire as the ceramic ignitor base could be damaged. See page 13 for
instructions.