Installation Guide

UNIQUE!24CT/30CT/36CT !
16
To Operate the Surface Burners
Knob Symbols
Off
Off
High Flame
Low Flame
Ignition
Burner Position
•
Lighting the burners
1. To obtain a flame more easily, light the burner before placing cookware on
the burner grate.
2. Decide which burner you’re igniting first using the screened diagram below
each burner knob. The black dot indicates the position of the burner you will
be igniting.
3. To light a burner, press the burner knob in and turn counter clockwise
within the dashed area. You will hear the electronic ignition clicking as you
continue to hold the knob down until the flame lights. Once the burner is lit
you can then release the knob.
4. After lighting the flame, turn the control knob to adjust the flame size as
required.
5. In the instance of a power outage when using the 110V electronic ignition
option, one can still use the cooktop by placing a lit match next to the
desired burner and proceed as already described. If using the battery ignition,
check that your batteries have adequate voltage by replacing them. If the
burner still does not light after a few attempts, check that the “burner cap”
and “flame cap” are correctly positioned and that there are no spider webs in
the burner cavity.