Installation Guide

UNIQUE!24CT/30CT/36CT !
12
• If during installation the seal around the frame does not sit flush within the
countertop at the corners, the corner radius (maximum 3/16" (4 mm) can be
carefully filed down to fit. The cooktop has a seal underneath to keep it
securely in position and water/debris from getting underneath cooktop base.
• Use the clips that are included to hold the base securely in place.
Installing the cooktop
• Remove the cooktop from its package and set aside all burners, burner caps
and grates.
• Before placing the cooktop into the cut-out,
flip the cooktop upside down and install the
gasket provided. Then flip the cooktop back
over and lower it centrally into the cut-out.
When doing so, make sure that the seal under
the cooktop sits flush with the countertop on
all sides. This is important to ensure an
effective seal. Do not use sealant.
• Use the 4 supplied clips to secure the base with the underside of the counter
top.
• Take each clip and slide it into each slot on the cooktop base, then loosely
fasten the clips to the cooktop with a Philips screwdriver with the screws
provided. Once this is done you’re now ready to secure the cooktop to the
underside of the cabinet.
• Tighten the cooktop to the underside of the counter until secure.