Use and Care Guide

Warning - DO NOT use a pin or wire when

cleaning the burner orifice as damage can occur to

the precision opening. This can cause damage to

the refrigerator or create a fire hazard. It will also

create extremely dangerous levels of carbon

monoxide.

o The inlet & outlet gas fittings on the refrigerator need to be checked

for leaks. Apply a non-corrosive bubble solution to the fittings and

observe for leaks. The safety valve will not allow gas pressure to any

connections between it and the burner orifice. These fittings must be

checked while burner is in operation (gas flow will be present between

safety valve and burner head).

WARNING – The gas button D (Fig. #5) must be

manually depressed to allow gas pressure to flow to the

burner orifice. Be sure to apply the leak check solution

before depressing the safety shut–off. DO NOT allow

any open flame, sparks, smoking, etc. in the area of the

test. DO NOT depress safety shut-off for over 30 seconds.

o If a leak occurs, then allow ten minutes to dissipate from the burner

area. Fix leak then light the burner according to the instructions under

GENERAL OPERATING INSTRUCTIONS – GAS OPERATION, CHAPTER 3.