User Manual

Table Of Contents

1.Firstly,be sure that using voltage is match with the voltage

marked on the base of the lighting;

2.Fix the laser and adjust the angle of the laser light to your need.

Don`t stare into the beam or view with optical instrument

3.Be sure that there is no flammable or explosive subject nearby.

The least distance is 0.5 meters.

4.The laser lighting should be fixed by inserting into soil

attached to trees etc;

5.It is essential to be earthed well for the stake of safety.

6.Adapter to be installed indoors or an outdoor

waterproof socket.

Installation

Garden light.

Rating AC 100-240V,50/60Hz

CLASS 2 LASER PRODUCT

MADE IN CHINA

Dimension:210x140MM

Garden light

User Manual

Thanks for your purchashing,please read this manual carefully

before operating the system,It gives you general information

for your safety and better operation.

PAGE 1
Dimension:210x140MM Installation 1.Firstly,be sure that using voltage is match with the voltage marked on the base of the lighting; Garden light 2.Fix the laser and adjust the angle of the laser light to your need. Don`t stare into the beam or view with optical instrument 3.Be sure that there is no flammable or explosive subject nearby. The least distance is 0.5 meters. 4.The laser lighting should be fixed by inserting into soil attached to trees etc; 5.
PAGE 2
Dimension:210x140MM Inspection Check for the contents in the package refers to the following list; 1.IP65 water-proof and dust-proof light:1 2.Adaptor :1 3.Power cord:1 4.Junction:1 5.Ground stake:1 6.Remote control:1 7.Screws:1 8.User Manual:1 Safety Attention Remote Control Instructions 1.Please pull the plastic sheet out which at the bottom of the Remote firstly, when you start to use the remote and pls put it back into the same place if you don't use it for a long time which can save the power.
PAGE 3
Dimension:210X140MM
PAGE 4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.