Service manual

1) Remove the gasket door(A09) from door seal as(A01).

2) Remove the door frame (A04) from door seal as(A01).

3) Remove the stopper hinge top(A08) from door seal as(A01).

4) Remove the spring(A03) and the hook(A02).

5) Remove the barrier screen outer(A07) from door frame(A04).

6) Remove two screws(A06) from door seal as(A01).

7) Remove the door handle (A05) from door seal as(A01).

8) Reverse the above steps for reassembly.

4. Method to reduce the gap between the door seal and the oven front surface.

(1) To reduce gap located on part A .

Loosen two screws on stopper hinge top, and then push the door

to contact the door seal to oven front surface.

Tighten two screws.

(2) To reduce gap located on part

B .

Loosen two screws on stopper hinge under, and then push the

door to contact the door seal to oven front surface.

Tighten two screws.

NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm