Owner`s manual

UNIQUE UGP 6C/8C/10C DV

Thermostat

The refrigerator cooling temperature is controlled by a combination thermostat that

can be adjusted by turning knob E to different settings to maintain the desired

refrigerator temperature. It also incorporates a safety device which automatically shuts

off the supply of gas if the flame goes out. The piezo electric igniter and/or the

electronic ignition discharges sparks onto the burner when the appropriate button is

pushed. See Figure #5

1. “MIN” Setting on the Gas Thermostat: In gas operation, the thermostat closes

its main valve and the burner runs continuously at the bypass rate or pilot flame.

(counter clockwise turn)

2. “MAX” Setting of the Thermostat: In gas operation, the thermostat allows the

burner to remain on high flame continuously. (Clockwise turn)

3. The thermostat can be adjusted between “Max” and “Min” (4 or 1) to obtain the

desired fridge temperature.

When the thermostat reaches the set temperature, it will cut the burner back to bypass

operation.

The setting of the thermostat is critical and recommend it be adjusted to maintain a dry

frost on the cooling fins (approx 38 Ferinheight or 3 Celsius). Adjust the thermostat

knob closer to “Max” (clockwise) when the outside temperature rises.

NOTE: When first turning refrigerator on, move refrigerator controls to maximum,

which is the recommended initial setting. After 24 hours, adjust the controls as needed.

How To Use The Refrigerator

FOOD STORAGE COMPARTMENT

The food storage compartment is completely closed and unventilated, this is necessary

to maintain the required low temperature for food storage. The coldest areas in the

refrigerator are under the cooling fins and at the bottom of the refrigerator. The

warmer areas are on the upper door shelves. This should be considered when placing

different types of food in the refrigerator.