Owner`s manual

UNIQUE UGP 6C/8C/10C DV

Shut Down Procedure – Gas Operation

1. Turn selector knob G to the OFF position

Shut the gas off at the LP-gas supply cylinder when the appliance is not in use.

3. If the refrigerator will not be in operation for a period of weeks, it should be

emptied, defrosted, cleaned and the doors left open.

110V Operation

1. Ensure the electrical cord is plugged into a grounded outlet

2. Turn the selector switch G to AC position, AC power indicator F will

illuminate

3. To start the refrigerator, turn the thermostat knob E to maximum setting.

4. Adjust the thermostat knob to desired temperature setting after 4 to 8 hours

of operation.

Note:

If ignition does not occur immediately while lighting the refrigerator, you have flooded the burner

box, wait 5 to 10 minutes and repeat. This time will allow the propane to dissipate then repeat the

lighting process again. The fridge must not run with any of its venting disconnected or with burner box

cover removed, except for servicing/testing the unit. Doing this will cause a danger of carbon monoxide

entering the room.

CONTROLS – See Fig 5. for description of controls

Figure 5

B C D E F G

Off