Owner`s manual

UNIQUE UGP 6C/8C/10C DV

Figure A

 Now prepare to drill holes in the interior wall for each the fresh air and flue

exhaust tube. Depending on what’s on your outside wall you will have to make

necessary adjustments in the drilling process.

 Take your adjustable drill bit or similar tool and set it to a diameter of approx

2.375” which is the outer diameter of the venting. We suggest you make it

slightly larger to allow for thicker/deeper walls, this will allow for a littlie play

if you do not have it lined up just right where measurements are not exact.

The extra space can be filled in with silicone afterwards.

 You now have your holes in the wall, the next step is to take each the fresh air

vent and flue exhaust vent and push them through from the exterior wall

inward. Make sure the long part of the “T” on the flue exhaust vent,

faces down – see below

Long Part Down

Flue Exhaust Vent